Red-D-Arc EXTREME 360 Spezifikationen

version 1.8

95.3. Operating via DyNet protocol1.Unplug from the mains before installation.2.Connect LED modules to the xtures.Connect rst xture to the control

10A description of each byte in DyNet protocol is the following: Byte 0: 1C - hexadecimal Logical Message (xed value)Byte 1: 01 - Area Byte 2: 00 –

116.ArcPower 360 - Control menu mapDefault settings=Bold print 001 (001-470) PrG E.P.1 E.P.2 E.P.3 P.01 : P.06 Aut (OFF,On)

127.ArcPower 360-DMX protocol Version 2.0 (software version 5.1 and higher)Mode/ChannelValue Function Type of control1 2 3 4 5ZONE 11 1 1 1 10-255Red

13Mode/ChannelValue Function Type of control1 2 3 4 5ZONE 719 25 25 1 10-255Red LED 7Red LED saturation control (0-100%) proportional20 26 262 20-255G

14Mode/ChannelValue Function Type of control1 2 3 4- - 41 -184-191192-199200-207208-215216-223224-231232-239240-247248-255Macro 23Macro 24Macro 25Macr

158.Control boardThe control panel situated on the top cover of the ArcPower 360 allows DMX addressing,calling Built-in pro-grams and setting the xtu

161. Enter "EdI." menu2. Press [UP] or [DOWN] to select the desired program which you wish to edit and press [ENTER].3. Press [UP] or [DOWN]

178.4 Test sequencesUse the item to run a special demo-test sequences without an external controller,which will show you some possibilities of using t

18Prt --- Protocol selection - Selects a required communication protocol. dMH - the xture will communicate using DMX 512 signal. dYn - the xture

19 9.Control of the ArcPower 360 via RS-2329.1Wiring an RS-232 serial port 9-pin D connector (male) Front view of t

20Type 1: Selection of the preset colours The syntax of the command is: zone Z red; zone Z green; zone Z blue; zone Z white; zone Z yellow

2110.Technical Specications:Power supply:Input Voltage: 100-240 V AC, 50/60 Hz Fuse:T 8 A HMax.Pover Consumption:840 VAInput:Control:DMX 512 or Dynet

22Weight: 6.3 kgOperating temperature:-10°C/+40°CAccessories: Cable joiner (No.13050691)...10 pcs Optional accessories: Adaptor RJ45/DMX 3

23

2Table of contents1. Safety instructions ... 32.

3CAUTION!Unplug mains lead before opening the housing!FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOU INITIAL START - UP!1. Saf

43.Description of the ArcPower 360 RJ45 socket LED zone Output Front view of the socket:

5installed following the manufacturer´s instructions.The earth has to be connected!Cord plug connections:Cable Pin Internationa

62.RJ45 patch cables category 5 that connect the ArcPower 360 each other are wired 1:1,that is,pins with the same numbers are connected together. P

7Multiple ArcPower 360 installation:Connect the DMX output of the rst ArcPower 360 with the DMX input of the next ArcPower 360. Always con-nect one o

85.2.Master-slave operating1.Unplug from the mains before installation.2.Connect the LED modules to the xtures.3.Connect the DMX output of the master