Red-D-Arc EXTREME 360 Spezifikationen PDF herunterladen (Seite 37)

OM-237 881 Page 33

7-6. Remote Process Select

This power source can be used with wire

feeders that support Remote Process Se-

lect. This feature allows the operator to

switch the active welding process between

MIG and Pulsed MIG at the wire feeder. To

determine if the welding system is Remote

Process Select capable, connect the wire

feeder to the power source and review the

power source display variations shown be-

low.

. When used with an XMT power source,

the Process Select knob must be set to

Pulsed MIG for Remote Process Select

to be active.

Power Source Display − Wire Feeder with

Remote Process Select Not Detected

When the power source Right Display is

blank, a wire feeder with Remote Process

Select is not detected. Set the active weld

process at the power source.

Power Source Display − Wire Feeder with

Remote Process Select Detected

When the power source Right Display is

MIG, a wire feeder with Remote Process Se-

lect is detected and set for MIG operation.

The active weld process can only be

changed at the wire feeder.

Power Source Display − Wire Feeder with

Remote Process Select Detected and Set

for Pulsed MIG

When the power source Right Display is

PULS, a Remote Process Select wire feeder

is detected and is set for Pulsed MIG opera-

tion. The active weld process can only be

changed at the wire feeder.

Using a Dual Wire Feeder with Remote

Process Select

When using a dual wire feeder with Remote

Process Select, different weld programs for

the left and right side can be selected. The

power source MIG and Pulsed MIG pro-

grams for the left side of wire feeder are se-

lected with the left side of the wire feeder act-

ive. The power source MIG and Pulsed MIG

programs for the right side are selected with

the right side of the wire feeder active. When

the right side of the wire feeder is active, the

power source Right Display will show a

decimal point in the lower right hand corner

as shown.

Power Source Display − Dual Wire Feed-

er with Right Side Active and Set for MIG

Power Source Display − Dual Wire Feed-

er with Right Side Active and Set for

Pulsed MIG

50

25.0

MIG

50

PULS

25.0

MIG.

50

PULS.

Decimal point indicates wire

feeder right side is active.

Decimal point indicates wire

feeder right side is active.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare