Red-D-Arc EXTREME 360 Spezifikationen PDF herunterladen (Seite 39)

OM-237 881 Page 35

7-8. V-Sense Feeder Welding Mode - GMAW/FCAW Process

! Weld terminals are energized at all

times in V-Sense Feeder welding

mode.

1 Mode Switch

2 Volts Indicator

3 Left Display

4 Right Display

5 Adjust Control

6 Wire Type Indicator

7 Arc Control Indicator

8 Setup Button

9 Gas Type Indicator

Setup

For typical system setup connections refer

to Section 7-7.

Rotate Mode Switch to V-SENSE FEEDER

position as shown.

The Left Display toggles between open cir-

cuit voltage and preset voltage with the

Volts Indicator lit.

Operation

While the Volts Indicator is lit under the Left

Display, the Adjust Control is used to set

desired preset voltage.

. The Left Display toggling momentarily

pauses while the preset voltage is ad-

justed.

Pressing the Setup Button allows adjust-

ment of Arc Control, Wire Type, Gas Type

and preset voltage.

. For best results, select the appropriate

Wire and Gas Type to match the actual

wire and gas being used.

Refer to MIG − Wire and Gas Selection

Table for available wires and gases (see

Section 7-3).

Selecting a Wire and Gas

Press the Setup Button repeatedly until the

Wire Type indicator is lit. The active Wire

Type will appear in the Left and Right Dis-

play.

Rotate Adjust Control to select desired

wire.

Press the Setup Button again so the Gas

Type indicator is lit. The active Gas Type

will appear in the Left and Right Display.

Rotate Adjust Control to select desired gas.

Press the Setup Button again to confirm the

selection. The unit will acknowledge a

change of wire and gas information by dis-

playing PROG LOAD momentarily.

Arc Control (Inductance)

Press the Setup Button repeatedly until the

Arc Control indicator is lit. INDU appears on

the Left Display, and the corresponding in-

ductance setting appears on the Right Dis-

play.

Rotate Adjust Control to select desired in-

ductance setting from 0 to 100. Use lower

inductance settings to stiffen the arc and re-

duce puddle fluidity. Use higher inductance

settings to soften the arc and increase

puddle fluidity.

Refer to the MIG − Wire and Gas Selection

Table (see Section 7-3) for suggested in-

ductance setting for the specific wire and

gas being used.

. Each Wire and Gas Type combination

has independent preset voltage and in-

ductance settings. These settings are

preserved when the unit is turned off.

226 611-A

1

5

5.0

2

43

2

6

7

8

9

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare