Red-D-Arc EXTREME 360 Spezifikationen PDF herunterladen (Seite 42)

OM-237 881 Page 38

8-2. CC Welding Mode - SMAW/CAC-A Process

! Weld terminals are energized

through the remote control in CC

welding mode.

1 Mode Switch

2 Left Display

3 Right Display

4 Amps Indicator

5 Adjust Control

6 Arc Control Indicator

7 Setup Button

Setup

For typical system connections refer to

Section 8-1.

Rotate Mode Switch to CC position as

shown.

The preset amperage is shown in the Right

Display with the Amps Indicator lit.

Operation

While the Amps Indicator is lit under the

Right Display, the Adjust Control is used to

set desired preset amperage.

A remote control is required to turn on the

weld output.

. If the remote control has an amperage

adjustment, the adjustment will func-

tion as a percentage of the preset am-

perage.

Pressing the Setup Button allows adjust-

ment of Arc Control, Hot Start Current and

Hot Start Time.

. For best results at the end of the weld,

pull back the electrode quickly to extin-

guish the arc.

Arc Control (Dig)

Press the Setup Button so the Arc Control

indicator is lit. DIG appears on the Left Dis-

play, and the corresponding dig setting ap-

pears on the Right Display.

Rotate Adjust Control to select desired dig

setting from 0 to 100.

Dig control allows the arc characteristics,

soft versus stiff, to be changed for specific

applications and electrodes. Lower the dig

setting for smooth running electrodes like

E7018 and increase the dig setting for stiff-

er, more penetrating electrodes like E6010.

Press the Setup Button repeatedly until the

Arc Control light goes out to return to ad-

justment of preset amperage.

Programmable Hot Start

Press the Setup button repeatedly until

HOT.S appears on the Left Display. HOT.S

adjusts the Hot Start Amperage to Adaptive

Hot Start (AUTO) or from Min (1) to Max

(50). Adaptive Hot Start (AUTO) automatic-

ally chooses a default amperage. The Min

(1) setting results in no hot start amperage.

Higher numbers result in higher start am-

perage.

Press the Setup button again so HOT.T ap-

pears on the Left Display. HOT.T adjusts

the Hot Start Time to Adaptive Hot Start

(AUTO) or from Min (1) to Max (50). Adapt-

ive Hot Start (AUTO) automatically

chooses a default Time. The Min (1) setting

results in no hot start time. Higher numbers

result in longer start time.

Press the Setup Button to return to adjust-

ment of preset amperage.

. Use this mode for Air Carbon Arc

(CAC−A) cutting and gouging. For best

results, adjust dig setting to maximum.

1

52

7

226 611-A

58

3

4

6

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare